CCS/CC1310: When using CCS7 to generate a HEX file, how to configure to generate code only in a specific flash area?

user5095674

Prodigy 205 points

Part Number: CC1310

Tool/software: Code Composer Studio

When using CCS7 to generate a HEX file, how to configure to generate code only in a specific flash area?

over 7 years ago

0 Hossein Forouzani over 7 years ago

Genius 3030 points

Hi,

Please take a look at links bellow. It's about similar matter.

I hope it helps.

Regards,
Hossein

0 user5095674 over 7 years ago in reply to Hossein Forouzani

Prodigy 205 points

thank you very much. But I still don't know how to set the specific address of flash in CCS. For example, I want to generate code from 0x8000, how to set it, I hope to be able to help

0 Ki over 7 years ago in reply to user5095674

TI__Guru**** 471881 points

Hello,
Please see Chapter 12 of the below user's guide:
www.ti.com/.../spnu118p.pdf

Thanks
ki

Code Composer Studio™︎

Code Composer Studio forum

CCS/CC1310: When using CCS7 to generate a HEX file, how to configure to generate code only in a specific flash area?