CCS/TMS320F28069M: The debug probe reported an error. Confirm debug probe configuration and connections, reset the debug probe, and retry the operation.

NAYAN KHULBE

Tool/software: Code Composer Studio

I am sending some AT commands to SIM900 which is connected to SCIA (UART) of my device.But after some time while running the program it is getting stopped and following error is coming.

The debug probe reported an error. Confirm debug probe configuration and connections, reset the debug probe, and retry the operation.

please help.

regards,

nayan

over 8 years ago

0 desouza over 8 years ago

TI__Guru**** 171839 points

Nayan,

As mentioned in the related thread, the error you mentioned is highly dependent on the firmware running on the device. With this in mind and the behaviour you described - i.e., the problem only happens after a while running - makes me believe there is either a buffer overrun or a memory leak that collapses the device's normal operation.

The experts in the C2000 forum are better equipped to help you with this. I will notify them of this thread.

Regards,
Rafael

0 Sean Bigley over 8 years ago in reply to desouza

TI__Genius 17175 points

Hi Nayan,

Are you still experiencing issues here? If not, I will mark this thread closed

Sean

Code Composer Studio™︎

Code Composer Studio forum

CCS/TMS320F28069M: The debug probe reported an error. Confirm debug probe configuration and connections, reset the debug probe, and retry the operation.