CCS/TM4C1294KCPDT: How to configure CCSv6 for using Keil Ulink

thierry Didi

Part Number: TM4C1294KCPDT
Other Parts Discussed in Thread: SEGGER

Tool/software: Code Composer Studio

Hello

Is it possible to connect CCSV6 to a TM4C1294 custom board through Keil Ulink 2 probe ? (this debug probe does not appear in the list when I try to configure the ccxml file ...)

Many thanks

Thierry

over 7 years ago

0 JohnS over 7 years ago

TI__Guru**** 162885 points

Thierry,

Unfortunately Keil uLink is not supported by CCS. CCS supports XDS debug probes as well as Segger JLink.

Regards,
John

0 thierry Didi over 7 years ago in reply to JohnS

Intellectual 410 points

Ok thanks for your reply. It's too bad since I did purchase this probe only for thi :(

Anyway I have been able to debug my board with a TM4C1294 dev kit which can be used for debuging external board, which is very a nice feature :)

Best Regards

Thierry

Code Composer Studio™︎

Code Composer Studio forum

CCS/TM4C1294KCPDT: How to configure CCSv6 for using Keil Ulink