CCS: How to debug in CCS using J-Link?

Juvf Anisimov

Intellectual 900 points

Other Parts Discussed in Thread: SEGGER

Tool/software: Code Composer Studio

I have win7-64 pro, ccs8.1. I installed SEGGER J-Link, SEGGER J-Link USB Driver, SEGGER J-Link USB Driver (Windows).

I made "Hello world" c++ progect. Target F28M35H52C1.

1)How to connetc J-Link to F28M35H52C1? what pins where? Where to connect EMU0 and EMU1?

2)How to use in CCS using J-Link? I go to Project->Properties->General->Project->Connection:, But there is no J-Link. Why?

over 7 years ago

0 Ki over 7 years ago

TI__Guru**** 463901 points

Hello,

The F28M35 is not supported by J-Link. While it does support Cortex-M3, it does not support C2000. Hence you will not be able to select J-Link for the F28M35 as a whole:

https://e2e.ti.com/support/development_tools/code_composer_studio/f/81/p/612394/2254666#2254666

It might be possible to create a custom configuration and bypass the 28x.

In any case, I would check with SEGGER to see if they have any updates or suggestions.

Thanks

Code Composer Studio™︎

Code Composer Studio forum

CCS: How to debug in CCS using J-Link?