CCS/TM4C1294NCPDT: Target not run as the symbol "main" is not defined

Zhuoqun Liu

Part Number: TM4C1294NCPDT

Tool/software: Code Composer Studio

Hi!

I am using a new tm4c1294NCPDT launchpad and I am trying to get the bootloader working on the TM4C1294NC9DT controller with CCS. When load the code to the controller, the following error occur:

What should I do with this error?

over 6 years ago

0 Ki over 6 years ago

TI__Guru**** 448541 points

Hello,
This is not an error but a warning. Basically, the debugger will try to auto-run to the start of the "main" function in your application. If you do not have a "main" function, then you would get the message you see. You can disable the autorun feature, or specify a new label to run to.

e2e.ti.com/.../1429818

Thanks
ki

0 Zhuoqun Liu over 6 years ago in reply to Ki

Prodigy 50 points

Thanks a lot!

Code Composer Studio™︎

Code Composer Studio forum

CCS/TM4C1294NCPDT: Target not run as the symbol "main" is not defined