CCS/EK-TM4C123GXL: UNABLE TO ADD BREAKPOINT AND SEE OUTPUT WHILE CONNECTED TO SENSOR HUB

annu kumari

Part Number: EK-TM4C123GXL

Tool/software: Code Composer Studio

I connected the TM4C123G6PM with sensor hub, but in ccs i am unable to get the output. Please guide me regarding steps to be followed.

over 6 years ago

0 JohnS over 6 years ago

TI__Guru**** 162305 points

Annu,

Have you successfully loaded a program onto the TM4C LaunchPad with CCS? What does it show in the debug view? Does it give you an error when trying to set a breakpoint?

This workshop shows the basics of using CCS with a TM4C LaunchPad.
dev.ti.com/.../node

In order to be able to help you I am going to need more information.

Regards,
John

0 JohnS over 6 years ago in reply to JohnS

TI__Guru**** 162305 points

Annu,

Have you looked at the workshop? If you are still having issues could you answer the questions in my previous post.

Regards,
John

0 JohnS over 6 years ago in reply to JohnS

TI__Guru**** 162305 points

Annu,

Since I have not heard back from you I am going to assume that you have gotten past this issue and will close this thread. If you are still having issues please feel to reply or to create a new thread.

Regards,
John

Code Composer Studio™︎

Code Composer Studio forum

CCS/EK-TM4C123GXL: UNABLE TO ADD BREAKPOINT AND SEE OUTPUT WHILE CONNECTED TO SENSOR HUB