CCS: I have been using texas instrument simulator with DSK6713. I wanted to access the DSPLIB C67X but get the error as ".out file does not amatch the target.

Gunjan Goyal

Tool/software: Code Composer Studio

I have been using texas instrument simulator with DSK6713. I wanted to access the DSPLIB C67X but get the error as ".out file does not match the target. How can I resolve this issue?

over 6 years ago

0 Ki over 6 years ago

TI__Guru**** 464471 points

Hello,
The build settings used to build the *.out file does not align with what is expected by the simulator. If you are using the C6713 device simulator, make sure the *.out file is built for C6713. Also make sure the endianness align (if using the little endian simulator, make sure you build the *.out file for little endian).

Thanks
ki

0 Gunjan Goyal over 6 years ago in reply to Ki

Prodigy 40 points

I have been using TMS320C6713 . The DSP library supported by this is DSPLIBC671X but it is not available for download anymore from TI website. How can I get it?

0 Ki over 6 years ago in reply to Gunjan Goyal

TI__Guru**** 464471 points

Which library do you have? You mentioned trying to load a *.out file. Did you build that *.out file for C6713? Did you use some other version of DSPLIB?

0 Ki over 6 years ago in reply to Ki

TI__Guru**** 464471 points

Hello,
I haven’t heard back from you, hence this issue is being closed. If you wish to continue the discussion, please post a reply with an update below (or create a new thread).

Thanks,
ki

Code Composer Studio™︎

Code Composer Studio forum

CCS: I have been using texas instrument simulator with DSK6713. I wanted to access the DSPLIB C67X but get the error as ".out file does not amatch the target.