• State Resolved
  • Locked Locked
  • Replies 5 replies
  • Subscribers 53 subscribers
  • Views 310 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CCS/TM4C1294NCPDT: TM4C1294NCPDT

Sergey uskach
Intellectual 690 points

Part Number: TM4C1294NCPDT
Other Parts Discussed in Thread: UNIFLASH

Tool/software: Code Composer Studio

Hi ,

I am trying to use Uniflash 6.0.0.2710 to program on chip flash using jtag debugger XDS110.

I have Uniflash undated XDS110 firmware to the latest. But when I am trying to access onchip flash from address 0x0 ,

I cannot do it.Here is screen shot. How I can access flash on my board using this Uniflash and XDS110.

Thanks

  • 0
    TI__Guru**** 171839 points

    Hi,

    Unfortunately the screenshot did not go through. Do you mean trying to access the Memory Read function of Uniflash, as shown in the short clip below?

    Regards,

    Rafael

  • 0 in reply to desouza
    Intellectual 690 points

    Hi Rafael:

    I am attaching screen shot of unflash  as word document.

    uniflash.docx

  • 0 in reply to Sergey uskach
    TI__Guru**** 171839 points

    Sergey,

    Thanks for sending the picture. You mentioned that you are using XDS110, but the screenshot shows your Uniflash is configured for XDS200. Can you re-configure your environment as shown in the (now fixed) video above and retry? 

    Regards,

    Rafael

  • 0 in reply to desouza
    Intellectual 690 points

    Hi Rafael:

    here is another 2 screen shots0871.uniflash.docx

  • 0 in reply to Sergey uskach
    TI__Guru**** 171839 points

    Hi,

    All this looks normal to me. What does it happen when you click on the button Read Target Device? Check the video for an expected output.

    Regards,

    Rafael