Compiler/TMS320F28379D: Can I use the code of Piccolo and into Delfino?

Thank you for your response but you mentioned the example is related to LLC control and I am having the example which is related to PFC control for that LLC.

I understand. I am routing your question to our digital power team for further assistance. In the meantime, it should be possible to migrate this solution to the F2837xD device. Similar to what I mentioned before be sure to update and include and file search paths in your project for the appropriate device. Also be sure to replace any device specific files.

-Ozino

Thank you Ozino for the clarification. I got the point just need to understand which files should I need to change and what changes I have to make ti migrate from piccolo to Delfino. Sure Please route my question to the digital power team. Thank you again

Just found this post mentions the kit in reference. Please see this thread and reference to a similar design, ILPFCKIT, the tidm-1022 is based on this kit and is supported in the C2000Ware-DigitalPower-SDK 

https://e2e.ti.com/support/microcontrollers/c2000/f/171/p/760593/2811024?tisearch=e2e-quicksearch&keymatch=HVPFC2Phil#2811024

Thank you Ozino for the reference. I have already that file but the problem is, it is for piccolo and I want to use this in Delfino so just need to know what are the changes I need to make it for the migration process. 

Thank you for that Ozino, Do I need to anything from my end for this routing process?

Any update Ozino? No one contacted me from the digital power team. Do I need to do any process to make a request?

An owner has been assigned. In order to port to the F2837x device you will need to start by replacing all files in the project that are named starting with "DSP2802x_" or similar with their equivalent "F2837xD" files. Second, you will want to go into the project properties, under Compiler-> include options update the paths referenced to the new f2837xd device locations. Repeat the same under Linker -> File search path.

Once you've updated those files and project properties, you will want to build the project and continue debugging from there.

Hope this helps

Thank you so much for the depth answer. I will follow your tips. So basically change the files and change the path of linker and compiler that's it. Do I need to take care of code? or any changes in coding?

I am looking for corresponding files for compiler, I got almost all files except 

C:/ti/controlSUITE/libs/app_libs/digital_power/f2802x_v2.0/include

and

C:/ti/controlSUITE/libs/app_libs/digital_power/f2802x_v2.0/asm

In compiler it was straight forward that but in linker its different story I can't figure it out where should I change the paths have a look

You will probably need to make some updates in software. Be on the look out for any settings related to the device clocks and pin selections. You can refer to the boards folder in controlSUITE and look at the layout of the device to know what pins are used and need to be  updated for the new device

If you expand the Linker options in the previous window, there is a subcategory named 'File Search Path' you can change the paths in that window.