New to PSPICE. I just created a new design schematic (File, New, Design). Attached.
But when I try to add a Voltage Marker, it says ERROR MARKER CANNOT BE PLACED ON A PAGE THAT IS NOT WITHIN THE CURRENT HIERARCHY
And when I try to run the simulation, it says CURRENT SCHEMATIC THAT YOU ARE EDITING IS NOT IN THE SIMULATION HIERARCHY.
I followed the video tutorial step for step, but apparently there are other setup requirements.
Can someone please point to a video tutorial that describes my issue?
Please point to a step-by-step tutorial for setting up "Current Hierarchy" and "Simulation Hierarchy"
Tks.