• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 37 subscribers
  • Views 192 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

tina tool

PRINCE ALEXIS
Prodigy 90 points

Hello Team, 

i am using TINA tool for my circuit simulation. In this tool, there is a possibility to create failure scenario of specific component. for example open circuit scenario. After selecting this i am not able to view the effect ie., the output of the simulation looks same even after selecting a specific fault scenario for a specific component. Is there a specific setting which needs to be enabled in the tool to view the effect ?

Could you kindly support me for this issue?

  • 0
    TI__Guru 71526 points

    Hello Prince,   

    Thank you for your inquiry about TINA.  Since TINA is a DesignSoft/TINA program, questions are handled by using the DesignSoft support page: http://www.tina.com/technical-support/  . 

    The DesignSoft/TINA team is very helpful and this is the most direct way for TINA support.  Please advise by clicking the    button when the problem has been solved.    

    Regards, 

    ~Leonard