Hi,
How can I find the antenna calibartion lockup table (Azimuth, elevation ... ) and how it was this done for the other boards like AWR2944 evm ? do you have any example of how it was managed in your demonstartion boards Fw?
Regards,
Amine
Dear Amine -
The AWR2243 devices have automatic built in calibrations which can be enabled or disabled.
You can use: AWR_RF_INIT_CALIBRATION_CONF_SB (details are in the Interface Control Document)
The Design Guide for the TIDA is here and test setup with results are shown at the end: https://www.ti.com/lit/pdf/tiduf12
Dear Amine -
You can read the AWR_CAL_DATA_SAVE_SB register for the contents of the calibrations
See the Interface Control Document for the details of the bytes (this register is 672 bytes)
