TINA-TI

Cuong Do

Other Parts Discussed in Thread: INA333, TINA-TI

Hi Everybody,

I'm a newbie of TINA-TI software. I want to test INA333, but I alway have problem: "Wire is not connect" at pin Vin-, when I run ERC in Analysis menu.

Please help me to solve this problem

Thanks

Cuong

over 13 years ago

0 Tom Hendrick over 13 years ago

TI__Guru**** 182821 points

Hi Cuong,

Welcome to the e2e Forum! Are you using the INA333 TINA-TI model found on the product page for the INA333 or did you wire up your own circuit? The implication of the error message is that pin 2 (the Vin(-) pin) is open. The TINA-TI example circuit works fine, so try using that as a starting point if you haven't already. You can find it here:

http://www.ti.com/litv/tsc/sboc264d

0 Nikhil Gupta (Product Folder Models) over 13 years ago

TI__Mastermind 39210 points

Hi Cuong,

This error could also mean that you have a floating wire connected to that pin. Loacting and removnig the floating wire may get rid of this problem. If you can share your TSC file, we can have a look to confirm.

Best regards,

0 Cuong Do over 13 years ago in reply to Tom Hendrick

Prodigy 40 points

Thanks for your help

0 Cuong Do over 13 years ago in reply to Nikhil Gupta (Product Folder Models)

Prodigy 40 points

7167.ina333.TSC

I had shared my file, but I do not sure you can read it.

Thanks for your help

Cuong

0 Nikhil Gupta (Product Folder Models) over 13 years ago in reply to Cuong Do

TI__Mastermind 39210 points

Hi Chuong,

As expected, it was a floating wire on the pin. For some reason, you had multiple wires on top of each other in several places in the design. I have cleaned it up. Please see attached. Note that the ERC check was only showing a floating wire "Warning" earlier (not an "Error"), so you could still run the simulation with it.

8117.ina333_mod.TSC

Let me know if you have any questions.

Best regards,

0 Cuong Do over 13 years ago in reply to Nikhil Gupta (Product Folder Models)

Prodigy 40 points

Hi Nikhil Gupta,

Thanks for your help,

Now problem is solved.

Best Regards

Cuong

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TINA-TI