Hi all,
i'm a beginner in using TINA so excuse me if i'm wrong, but, if i try to simulate a circuit with a battery all it's ok, but if i replace that battery with a real component that deliver same
voltage i need, suddenly i get no output from my FDA.
Can you please explain me this?
Thanks in advance.
MR
Hi Mariano,
We took a look at the simulation you posted and here is a quick suggestion that you can try in your simulation.
In TINA go the analysis tab and navigate to analysis parameters
Click analysis parameters and you should see a dialog window like the following one. Change the shunt conductance from 0 to 1n and rerun you simulation.
Let me know if this helps. Should you any more questions please feel free to repost.
Regards,
-Marcos
