LMR62014 spice model

Tom Penick

Other Parts Discussed in Thread: LMR62014

I would like to simulate the LMR62014 using the Texas Instruments Tina simulation software. Is there a .CIR file or other spice model that can be used by Tina? Since it can be simulated in WeBench, a spice model must exist but I cannot find it.

over 11 years ago

0 Nikhil Gupta (Product Folder Models) over 11 years ago

TI__Mastermind 39210 points

Hi Tom,

This part does not have a SPICE model at this time and one does not exist inside WEBENCH either. Where did you find the SPICE model you are referring to?

Thanks,

0 Tom Penick1 over 11 years ago in reply to Nikhil Gupta (Product Folder Models)

Prodigy 10 points

The Webench application appears on the product page for the LMR62014 at

http://www.ti.com/product/LMR62014

I assumed that meant that it can be used to simulate. I just tried it and Webench does

list the component.

0 Nikhil Gupta (Product Folder Models) over 11 years ago in reply to Tom Penick1

TI__Mastermind 39210 points

Hi Tom,

The WEBENCH Tool can be used for design, simulation, CAD Export and additional tasks. At this time all features are not enabled for the parts although we are trying to rectify this and add more features. At this time simulation is not enabled for this part. If you want to simulate a design, I would recommend choosing a part from WEBENCH design recommendations that has that feature enabled (look for red sine wave) and has design parameters close to what were produced for LMR62014.

If you can provide me your VIN, VOUT and Load conditions, I can help you with this.

Sorry for the inconvenience.

Best regards,

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

LMR62014 spice model