Tina - Change default setting simulation view

Eric Boutet1

Other Parts Discussed in Thread: TINA-TI

Hi,

I would like to know if there any way to change the default setting view in the graph simulation ? I would have the separate output curve by default when I I create a transient simulation by example...

Thanks for helping me.

over 12 years ago

0 Arash Loloee over 12 years ago

TI__Mastermind 33111 points

Hi Eric,

If you want to have the waveform being ploted seperatly by default, just change the label of one of the probes, say the output, to " Vout:1". This can be done by clicking on the probe. Then everything will be ploted separately.

Regards,

Arash

0 Britt Brooks - Online Design Tools over 12 years ago

TI__Mastermind 41310 points

Eric,

The easiest way to get TINA to automatically separate the curves is to simply name 1 of the signals that you want to graph with a :1 on the end of it. This is an undocumented feature in TINA-TI.

For example, if you want a signal named Vout, name it Vout:1 and the plots will automatically use the separate curves option, with Vout being the first trace listed.

Britt

0 Eric Boutet1 over 12 years ago in reply to Britt Brooks - Online Design Tools

Prodigy 20 points

Thanks for answer !! It works !! :-)

0 Dorian Hildebrandt over 10 years ago in reply to Britt Brooks - Online Design Tools

Prodigy 130 points

Awesome. I searched for an option a lot of times, and coundnt find anything.

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

Tina - Change default setting simulation view