WEBENCH Coil Designer schematic export problem

Sang Ho LEE3

Prodigy 120 points

Hello,

I have problem in drawing exported CAD file in eagle. This is my sequence.

1. Export CAD design for eagle from WEBENCH Coil Designer web site.
URL: http://webench.ti.com/wb5/LDC/#/spirals

File: 2015-04-22_07-47-35.zip

2. I found brd file and open with eagle CAD.

From here, I have problem in drawing schematic with this brd file. Would you guide how to make schematic?

Sincerly,

Anton Lee

over 10 years ago

0 Shrikrishna Srinivasan over 10 years ago

TI__Prodigy 420 points

Anton,

We don't have a specific schematic that goes with the layout, although, you could use an inductor symbol to represent the PCB coil inductor and a capacitor symbol to represent the capacitor in the layout for schematic purposes. Does that answer your question? Please let us know if doesn't.

Regards,
Shrikrishna,
WEBENCH,
Texas Instruments

0 Sang Ho LEE3 over 10 years ago in reply to Shrikrishna Srinivasan

Prodigy 120 points

Shrikrishna,

Thanks for your reply. I see there is no schematic in that. So I tried to make it, but I failed with error. Can you explain how to match symbol with exported brd file?

Sincerly,

Anton.

0 Howard Chen-WEBENCH Design Center over 10 years ago in reply to Sang Ho LEE3

TI__Expert 6365 points

Hello Anton,

Sorry for the delay. Attached zipped file contains both the instructions on how to link a new schematic to the brd file and an example of entire project in Eagle 7.1.

LDC1000.zip

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

WEBENCH Coil Designer schematic export problem