3D model needed for TPS6123x

Kathy Saghi

Prodigy 200 points

Where can I get a 3D .stp model for the TPS6123x?

Thanks,

Kathy

over 11 years ago

0 Joseph Wu over 11 years ago

TI__Guru** 100955 points

Kathy,

I've moved this post from the /etc...Data Converters forum to the Simulation Models Forum under the WEBENCH Design Center. I'm pretty sure that they can help with the .stp file. If not, this post might later be moved to the Non-Isolated DC/DC Forum where they cover this device.

Joseph Wu

0 Oliver Landine - WEBENCH® Design Center over 11 years ago

TI__Expert 3055 points

Hi Kathy,

Is it safe to assume the desired part number(s) contain the letters "DRC"? There are some upcoming parts that use the RWL package designator. I want to make sure our modeling team creates the right one for you asap.

-Oliver

0 Kathy Saghi over 11 years ago in reply to Joseph Wu

Prodigy 200 points

Thank you, Joseph. I wasn't sure where it belonged. I saw that some people had posted some questions about it under the Non-isolated DC/DC forum, but I couldn't find that either. I appreciate your help getting this in the right place.

Regard,

Kathy

0 Kathy Saghi over 11 years ago in reply to Oliver Landine - WEBENCH® Design Center

Prodigy 200 points

Hi Oliver,

Yes, the full part number is TPS61230DRCR. Thank you for checking and getting a model created for me!

Regards,
Kathy

0 Oliver Landine - WEBENCH® Design Center over 11 years ago in reply to Kathy Saghi

TI__Expert 3055 points

The modeling guys are rocking it right now. Here you go, Kathy.

DRC0010G.zip

0 Kathy Saghi over 11 years ago in reply to Oliver Landine - WEBENCH® Design Center

Prodigy 200 points

That was quick! Thank you for your help with this, Oliver.

Kathy

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

3D model needed for TPS6123x