Hello
I try to simulate the LM3886 behavior by using the TINA-TI spice tool and drawing the circuit that is listed in Figure 3 of the datasheet.
For some reason I get the following error: "INP does not match any pin of the macro element {LM3886}"
What can be the reason for this error?
Thanks.
Hi Semion,
Can you post your TSC file (Reference Design) to the forum. It will help to debug your specific issue.
Note that there is a TINA-TI Reference Design on the web already and it runs fine without any issue. You can try using that as a stating point and modifying it to match the circuit you want.
Thanks,
