TPS63030 PSpice model

Christoph Marko

Other Parts Discussed in Thread: TPS63030, TINA-TI, BQ25504

Hi,

for an exact test of my system I have to use the TPS63030. Where could I download Pspice, is there an open source also available?

Greetings,

Chris

over 9 years ago

0 Britt Brooks - Online Design Tools over 9 years ago

TI__Mastermind 41310 points

Chris,

PSpice is a simulation tool that is sold by Cadence as part of their simulation suite of tools. There is a "free" version, however, it is very node limited and cannot run encrypted PSpice models. The PSpice models in the TI product folders require PSpice version 15.7 or higher.

We can provide a TINA-TI model for the TPS63030 (TINA-TI is a free simulator you can download from TI's website). If that solution will not work, we can provide the unencrypted PSpice model, however, that would require an NDA in this case. Instructions for how to obtain the unencrypted PSpice model can be found here:

0 Christoph Marko over 9 years ago in reply to Britt Brooks - Online Design Tools

Expert 1450 points

Hi Britt,

that sounds good to me, may it be possible to send me the TPS63030 model?

Thanks

Chris

0 Christoph Marko over 9 years ago in reply to Britt Brooks - Online Design Tools

Expert 1450 points

Hi Britt,

do you know where I get the footprint for the TPS63030 for the altium designer ?
thanks

0 Oliver Landine - WEBENCH® Design Center over 9 years ago in reply to Christoph Marko

TI__Expert 3055 points

Hi Christoph,

I'm attaching the requested footprint.

Regards,

Oliver

DSK0010A.zip

0 Christoph Marko over 9 years ago in reply to Oliver Landine - WEBENCH® Design Center

Expert 1450 points

hi oliver,

is this the footprint for the TPS63030 because of the name of the file?

Chris

0 Oliver Landine - WEBENCH® Design Center over 9 years ago in reply to Christoph Marko

TI__Expert 3055 points

DSK0010A is the footprint for TPS63030.

Regards,
Oliver

0 Christoph Marko over 9 years ago in reply to Oliver Landine - WEBENCH® Design Center

Expert 1450 points

thank you a lot oliver ;)

0 Christoph Marko over 9 years ago in reply to Britt Brooks - Online Design Tools

Expert 1450 points

Hy Britt,
i downloaded the TPS63030 model from the TI homepage and I wanted to run it in the TINA-TI.
I couldn't import the file, than I loaded the PSpice Model Library and a editor window appeared but I didn't know how to change the parameters.

0 Christoph Marko over 9 years ago in reply to Christoph Marko

Expert 1450 points

hey guys,

do you have also a library for the BQ25504?

Greetings,

Chris

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TPS63030 PSpice model