Limit minimum package size?

Jared Schroeder

I was wondering if there is a way to limit the minimum package size that webench is selecting to nothing less than say 0603?

I have tried to select a different part for some items but it will regenerate the values at each save andswitches a previously changed component back to say a 01005.

over 9 years ago

0 Jason over 9 years ago

TI__Intellectual 805 points

Hi Jared,

You can filter your package size of your passive components in your design. To do this go into the visualizer and below your input requirements you will see a use advance options button. Here you can select the minimum package size that will be used in the design.

Cheers!

Jason

0 Jared Schroeder over 9 years ago in reply to Jason

Prodigy 50 points

So when I went in there to check it out, I only see that you can set that under the power designer options and not under LED designer is that correct?

0 Abhishek Gupta - WEBENCH Design Center over 9 years ago in reply to Jared Schroeder

TI__Intellectual 890 points

Hi Jared,
That is correct. At this point we have Advanced Options Minimum Package feature enabled for Power designer but not LED designer.
Regards,
-Abhishek

0 Jared Schroeder over 9 years ago in reply to Abhishek Gupta - WEBENCH Design Center

Prodigy 50 points

Okay thank you, I'll try to make it work as is.

Thanks
Jared

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

Limit minimum package size?