WEBENCH-POWER-DESIGNER: TPS62590 WEBENCH simulation

K. Sasaki14

Guru 10200 points

Part Number: WEBENCH-POWER-DESIGNER
Other Parts Discussed in Thread: TPS62590, TINA-TI

We can't edit the input and output condition on WEBENCH with TPS62590. The simulation condition is fixed.

I want to simulate with other using condition. Could you support this?

Best Regards,
Kohei Sasaki

over 8 years ago

0 Britt Brooks - Online Design Tools over 8 years ago

TI__Mastermind 41310 points

Sasaki-san,

There was an issue with the simulation of the device. The issue has been resolved and you should now be able to simulate using the device. You may also export the simulation to TINA-TI from the tool as well.

Please let us know if you have any additional issues.

0 K. Sasaki14 over 8 years ago in reply to Britt Brooks - Online Design Tools

Guru 10200 points

Britt-san,

Thank you for your reply.
Isn't the WEBENCH fixed that we can use it like other device?
We would like to change input output condition and check reference schematic with WEBENCH.

Best Regards,
Kohei Sasaki

0 Britt Brooks - Online Design Tools over 8 years ago in reply to K. Sasaki14

TI__Mastermind 41310 points

Sasaki-san,

This device is NOT set up like the other devices in WEBENCH. It is set up for simulation only. You can change the conditions of simulation using the schematic editor feature that the device loads into from the product folder.

If you prefer, you can create the default design and export the design to TINA-TI and modify it in TINA-TI. You can change the circuit and conditions there as well.

You will have to use the datasheet information to create the circuit. It recommends inductors and capacitors to use for the best performance.

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

WEBENCH-POWER-DESIGNER: TPS62590 WEBENCH simulation