TINA/Spice/BQ25504: How to import BQ25504 Spice Model

g.f.

Guru 15520 points

Part Number: BQ25504
Other Parts Discussed in Thread: TINA-TI,

Tool/software: TINA-TI or Spice Models

Hi,

I have a question about BQ25504 TINA-TI Transient Spice Model.

I want to import above spice model to TINA9-TI.
I tried as following procedure:

1.Select "PSpice Netlist(*.CIR)..." from TINA menubar-> File-> Import
2.Select BQ25504_TRANS.LIB from BQ25504_TINA_TRANS file which I downloaded from TI home page.

But I can't import the Spice model to TINA-TI.

This is my first time using TINA-TI and I don't know how to use it so far.
Please give me an advise for importing this spice model.

best regards,
g.f.

over 7 years ago

0 Imran Dharwad over 7 years ago

TI__Intellectual 1440 points

Hello,

The imported files for TINA-TI along with a Reference design is readily available in Product folder: www.ti.com/.../toolssoftware
You can use the reference design and modify as per your requirements.
Please note that we cannot import a encrypted spice model in TINA-TI to create a macro.

The procedure to import unencrypted spice models to TINA-TI can be found at this link:
e2e.ti.com/.../3059.importing-unencrypted-pspice-models-into-tina-ti

Let me know if you have any questions.

0 Nikhil Gupta (Product Folder Models) over 7 years ago

TI__Mastermind 39210 points

Hi g.f,

Since you are new to TINA-TI, it might also be helpful to go through the short video training series series. This will answer most of the commonly asked questions and help you get ramped up quickly.

0 g.f. over 7 years ago in reply to Imran Dharwad

Guru 15520 points

Hi Imran and Nikhil,

Thank you for the reply.
Now, I'm able to import the BQ25504 spice model.

best regards,
g.f.

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TINA/Spice/BQ25504: How to import BQ25504 Spice Model