This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software: WEBENCH® Design Tools
Hi,
i want to simulate the DC/DC Project (8V -- 125V/0.2A) with webench Designer using LM5022, but i found this problem ''simulation fault'',
i not have changed any component.
Best regards
Aymane LAKHAL
Hi Lakhal,
We are working on this issue. We will keep you posted on the same in the below e2e post
https://e2e.ti.com/support/development_tools/webench_design_center/f/235/p/685868/2528198#2528198
Hence we will close this post & continue discussion in above post.
Thanks and Regards,
Harish