TINA/Spice/CSD19534Q5A: CSD19534Q5A

Hi Ricardo,

Could you please share the reference schematic you are using to configure this schematic?
This will help us to look further into the issue.

Thanks,
Vivek Agarwal

Vivek,

I am not quite sure what you are asking, I created a similar design on Webench that uses the CSD19534Q5A Mosfet. The link can be seen below.

https://webench.ti.com/appinfo/webench/scripts/SDP.cgi?ID=5D2C0F52CD26F74C

Ricardo Portals

Vivek,

Thank you, I will use this model in my design. I was also looking at a rectifier controller in my design, then LM74670-Q1 to lower my voltage loss. Unfortunately I get the same error message when I try to run the transient analysis? What is it that is causing this and how do I fix it?

Hi Ricardo,

Could you please share the TINA-TI schematic in which you are observing error message?

This will help us to look into the issue.

Thanks,

Vivek Agarwal