WEBENCH® Tools/TPD8E003: TPD8E003 Design Verification

Aakash Dey

Part Number: TPD8E003

Tool/software: WEBENCH® Design Tools

I want to use TPD8E003DQDR (ESD Protector) for ESD protection of my SD card interface in my circuit. I have read the datasheet and found some guidelines regarding PCB trace routing. I have routed the signals. I want to verify my design from your side. Can you help me?

I am attaching the eagle design file.

OMNI_v1.3.5.sch OMNI_v1.3.5.brd

over 6 years ago

0 Cameron Phillips over 6 years ago

TI__Genius 12410 points

Hello,

I do not have access to see the brd file. Can you send me a picture of the layout of the device?

0 Aakash Dey over 6 years ago in reply to Cameron Phillips

Intellectual 590 points

Please go through the above image.

0 Cameron Phillips over 5 years ago in reply to Aakash Dey

TI__Genius 12410 points

Hello,

I do not see an issue with this layout

0 Aakash Dey over 5 years ago in reply to Cameron Phillips

Intellectual 590 points

Hello Phillips,

OK. I have routed the above by taking the reference itself. I have tried my best but, I was not able to follow the guidelines as per as datasheet completely.So, I want to verify my layout design from you.

If my schematic is OK, Can I Proceed towards implementing this?

0 Cameron Phillips over 5 years ago in reply to Aakash Dey

TI__Genius 12410 points

Hello,

Yes it is ok

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

WEBENCH® Tools/TPD8E003: TPD8E003 Design Verification