TIDA-00449: INTERFACE WITH MSP430G2553

Gowthamraj K

Part Number: TIDA-00449
Other Parts Discussed in Thread: MSP430G2553, MSP430G2533

Hello,

How to interface between TIDA-00449 to PC through UART, USB to serial interface is enough or any debugger is necessary ?,

I have got firmware for TIDA-00449 but need to know how to use, Please attach few references which would be helpful.

Thanks,

Gowtham

over 6 years ago

0 Ryan Tan over 6 years ago

TI__Expert 3356 points

Hi Gowtham,

If you have the firmware, i assume you would like to download the firmware and debug it. if so, i suggest you to use SBW. The easy way is to use a MSP430 launchpad and connect MSP430G2553 (SBWTCK & SBWDIO & GND) to the Target side as below:

0 Ryan Tan over 6 years ago in reply to Ryan Tan

TI__Expert 3356 points

Hi,

i don't know why the attachment is removed.

you can refer below link for the launchpad:

http://www.ti.com/lit/ug/slau680/slau680.pdf

Figure 17, J101

0 Gowthamraj K over 6 years ago in reply to Ryan Tan

Prodigy 70 points

HI,

So, i need to have MSP430G2533 launchpad kit to interface with TIDA-00449 for onboard programming .

Debugger like this http://www.ti.com/tool/MSP-FET.

0 Ryan Tan over 6 years ago in reply to Gowthamraj K

TI__Expert 3356 points

Hi,

Any MSP430 MCU launchpad works. what you need is only the debugger on the launchpad.

A debugger also works.

Best Regards,

Ryan

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TIDA-00449: INTERFACE WITH MSP430G2553