This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS51125

Other Parts Discussed in Thread: TPS51125

I am running PSPICE to simulate TPS51125. If connecting pin EN0 with 620K and bringing down to GND as in the data sheet shown, the output voltages were approximately  0. However, connecting pin EN0 with 1.5V as in your simulation model, the output voltages were 5V and 3.3V as we expected.

So, please give us the advice about this case. Because we will bring up our product soon.

 

BEst regards,

Thu