WEBENCH® Tools/TIDA-00618: UCC28911D

Angelo Menhem

Part Number: TIDA-00618
Other Parts Discussed in Thread: UCC28911

Tool/software: WEBENCH® Design Tools

Hey there,

I would like to adapt the TIDA-00618 design to produce 5V/100mA and 40V/200mA outputs buy could find a way in Webench to design such a topology.
Can someone guide me in this subject?
Regards

Angelo

over 5 years ago

0 Hong Huang over 5 years ago

TI__Guru 74115 points

You need to go to ti.com and search UCC28911 and find Webench then input your design specs to the table.

0 Angelo Menhem over 5 years ago in reply to Hong Huang

Prodigy 170 points

Thanks for your reply, but I couldn't find a way to configure DUAL OUTPUT topology.

Regards

0 Hong Huang over 5 years ago in reply to Angelo Menhem

TI__Guru 74115 points

Hi,

For a multiple output design, first design with a single output with all other output power on this single output. After you achieve the single output design then adding more outputs and split the power to each output, and change the transformer turns ratios to each.

This is a design process for multiple output flyback.

0 Angelo Menhem over 5 years ago in reply to Hong Huang

Prodigy 170 points

OK, thanks. I will do so.

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

WEBENCH® Tools/TIDA-00618: UCC28911D