ORPSIM-16144

Hello ACGUY,

Since TINA is a DesignSoft/TINA program, questions such as yours are best handled by using the DesignSoft support page:
 http://www.tina.com/technical-support/  . 

The DesignSoft/TINA team is very helpful and this is the most direct way for TINA support. 
If you choose to contact TINA directly, and your questions are resolved, please let us know by replying here.

Hello Ed,

I using the Pspice_for_TI. I searched about error "ORPSIM-16144" on google. But i could not to get the hint for the error.

If you know the specialist for Pspice, could you let me know my concerns to that person?

Best regards,

ACGUY

Hi ACGUY,

You can view the location of the error in the simulation output file.

Select "View" -> "Output file".

A new tab will open showing the .OUT file. You will see the same error message beneath the line where the error is.

Thanks,
JC

Hello ACGUY.

Were you able to get rid of the sim error?

Please let us know one way or the other.

Regards,
John

Hi John,

The circuit diagram I drew had a 0Ω resistor. This is to distinguish the node names.
The concern was resolved by setting the resistance value to 1 mΩ.

Thank you!
ACGUY

Thank you for letting me know.

John