• State Resolved
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 38 subscribers
  • Views 491 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Spice components for TPS23756EVM

Sivakumar S G
Prodigy 235 points

Other Parts Discussed in Thread: TPS23756, TINA-TI, TPS23756EVM

Hi,

I am trying to simulate and do analysis PoE TPS23756 in TINA-TI.

But I didn't get all components.

May I know from where I can get the components for simulating in TINA.

Regards,

Sivakumar

  • 0
    TI__Mastermind 21320 points

    Hello,

    We do not have models for the TPS23756. Instead, we offer evaluation modules and reference designs. The complexity of simulation is daunting and consuming, while the accuracy and relevance is limited. So we offer real data of our parts on boards. I highly encourage you to order a TPS23756EVM and run the tests that answer your performance questions (if they are not already done so in the User's Guide).

    If this post answers your question, please indicate so by marking this thread as resolved. Thank you.

     

    Regards, 

     

    Michael P.

    Applications Engineer

    Texas Instruments 

  • 0 in reply to Michael Pahl
    Prodigy 235 points

    Hi Michael,

    I have already bought tps23756 evm. I have to do the noise and worst-case analysis. So simulating the circuit might help in these.

    Is there any way to find the library for spice models of the parts in the evaluation module?

    Regards,

    Sivakumar

  • 0 in reply to Michael Pahl
    Prodigy 235 points

    Hi,

    We have already bought tps23756 evm. We are designing an IP Camera in which we use the same tps23756 circuit as in the datasheet. We need the circuit to meet the requirements as per the EN 55022 standard. Simulating the circuit might help in EMI EMC test. So we need the spice parts of components of the circuit for the analysis.

    Regards,

    Sivakumar

  • 0 in reply to Sivakumar S G
    TI__Mastermind 21320 points

    Hey Sivakumar, 

    I can check with R&D but I do not think they are available. Since EMI and EMC are system level requirements, it is best to test it. EMI and EMC is heavily dependent on layout. You can also add common mode choke, common mode caps, and ferrite beads to help. 

    Thanks!

    If this post answers your question, please indicate so by marking this thread as resolved. Thank you.

     

    Regards, 

     

    Michael P.

    Applications Engineer

    Texas Instruments 

  • 0 in reply to Michael Pahl
    Prodigy 235 points

    Hi,

    We would like to do EMI and EMC test on the evaluation module. If you have done the same, would you share the paper or application note?

    Regards,

    Sivakumar