CC2652R: program not running after hardware reset

Mohamed Aslam

Part Number: CC2652R

Hi all,

I am trying to integrate my existing project into OAD project. For this purpose, I am testing the simple peripheral off chip oad project which I am imported it from the sdk. But the program is not running after the hardware reset.

Still, I am not integrated OAD into my project. Example OAD project itself not running after the hardware reset. Please help me on this.

Regards,

Aslam

over 3 years ago

0 YiKai Chen over 3 years ago

Guru 735685 points

Make sure you also download BIM into your CC2652R.

0 Mohamed Aslam over 3 years ago in reply to YiKai Chen

Intellectual 310 points

Hi Chen,

Can you give me any procedure to do this. And how many sectors are allocated for storing the incoming image. I want to store my application data in external flash, so from which sector shall I start storing my application data

Regards,

Aslam

0 YiKai Chen over 3 years ago in reply to Mohamed Aslam

Guru 735685 points

I would suggest you to refer to SimpleLink Academy BLE Enhanced OAD.

0 Simon Huo over 3 years ago in reply to Mohamed Aslam

TI__Intellectual 1930 points

Hi Aslam, as for your second question, please open another thread, I'll look into it and give you feedback ASAP

Mohamed Aslam said:
And how many sectors are allocated for storing the incoming image. I want to store my application data in external flash, so from which sector shall I start storing my application data

0 Simon Huo over 3 years ago in reply to Simon Huo

TI__Intellectual 1930 points

I'm going to close this thread, please feel free to respond if anything else come up.

Bluetooth®︎

Bluetooth forum

CC2652R: program not running after hardware reset