Other Parts Discussed in Thread: LAUNCHXL-CC26X2R1
I am using the cc2642 for multiple projects now and i have an issue where the device behaves weirdly when repowered down and up again.
I am using GPtimers to open/close some pins that are connected to external bridge, when i connect the debugger and flash the firmware the device works perfectly, the timers are very precise and everything works as intended, however when I restart the device after that by the power switch, the timers just go crazy and the precision is lost.
is this Initialization related ? gel file ? and if so, do i need to write the procedures to initialize the device?