CC2652R: Help to compile documentation for certification

Stefano Tebaldi

Part Number: CC2652R

Hello,

I have to do BT certification of a product based on CC2652R. Certification entity is Dekra. They asked to compile some document:

- FDT30_18

- RF_PHY.IXIT.p18

- RF-PHY.ICS.p8

In particular, for the RF_PHY.IXIT there are a lot of PHY specific parameters to indicate. There can I found this information to compile in the right way the documentsc?

Thank you

over 2 years ago

0 Jan over 2 years ago

TI__Mastermind 42870 points

Hi,

I would recommend referencing the How to Certify Your Bluetooth Product application report as this contains very valuable information on how to certify you Bluetooth product. The document discusses how to perform Bluetooth RF testing and other useful details. If you are testing using a Bluetooth tester, then I would also suggest referencing the Configuring Bluetooth LE devices for Direct Test Mode app note. This second app notes provides valuable instructions for how to place the device in Direct Test Mode and how to send commands to the device with a bluetooth tester.

For specific information regarding tests, please reach out to your Bluetooth Qualification Consultant (BQC).

Best Regards,

Jan

0 Stefano Tebaldi over 2 years ago in reply to Jan

Prodigy 110 points

Hello,

thank you for the document

I have already the DTM enabled on my product. I am able to send HCI commands needed for DTM (HCI_LE_Transmitter_Test, HCI_LE_Receiver_Test and HCI_LE_Test_End) with a sw on PC via uart connection. The problem is the data to fill in the ICS and in particular the IXIT documents.

In the first pdf you indicated, I found this table

So I suppose I have to use the values of the CC26xx column.

0 Jan over 2 years ago in reply to Stefano Tebaldi

TI__Mastermind 42870 points

Hi,

I believe that is correct. However, please confirm if that is the case with your BQC.

Best Regards,

Jan

0 Stefano Tebaldi over 2 years ago in reply to Jan

Prodigy 110 points

Who is Bluetooth Qualification Consultant ? Someone from Dekra ?

I don't have a BQC

0 Jan over 2 years ago in reply to Stefano Tebaldi

TI__Mastermind 42870 points

Hi,

A Bluetooth Qualification Consultant is an independent consultant that help companies that are planning to qualify their bluetooth products with the process. The following page by the Bluetooth SIG provides some more information about them: https://www.bluetooth.com/develop-with-bluetooth/qualification-listing/qualification-consultants/

Best Regards,

Jan

Bluetooth®︎

Bluetooth forum

CC2652R: Help to compile documentation for certification