CC2651R3SIPA: Configure UART baudrate of host_test on CC2651R3SIPA

hiroki-okazaki

Prodigy 50 points

Part Number: CC2651R3SIPA
Other Parts Discussed in Thread: , UNIFLASH

Tool/software:

Hi,

I execute host_test on CC2651R3SIPA (LP-CC2651R3SIPA).

When the UART baudrate is set except 115,200 by system configration,

PC tool(BTool) cannot communication.
BTool was also set to same baudrate.

Why?

B.R. Hiro

1 month ago

0 Ivan 1 month ago

TI__Intellectual 1410 points

Hi Hiro,

Thanks for reaching out. Did you double check the COM interface? Are you able to execute the host_test example on Uniflash then use the BTool? Can you also confirm which SDK and CCS version you are using?

Regards

Ivan

0 hiroki-okazaki 1 month ago in reply to Ivan

Prodigy 50 points

Hi Ivan--san,

Thank you very much for your reply.

COM interface is OK.
host_test example is able to executed afte loaded from Uniflash.
And, BTool can be used also.
SDK: simplelink_cc13xx_cc26xx_sdk_7_41_00_17

CCS Version: 12.7.1.00001

B.R. Hiro

0 hiroki-okazaki 1 month ago in reply to Ivan

Prodigy 50 points

Hi Ivan--san,

I modified the Baud Rate on attached image only.

If there are others configuration, let's me know them.

B.R Hiro

+1 Clément 1 month ago in reply to hiroki-okazaki

TI__Guru* 96830 points

Hello Hiro,

The baudrate used by the device for the HCI communication should be modified in the project in the file <Project>/NPI/Transport/UART/npi_tl_uart.h or by pre-defining the symbol NPI_UART_BR

I hope this will help,

Best regards,

0 hiroki-okazaki 1 month ago in reply to Clément

Prodigy 50 points

Hello

Thank you very much for your reply.

I resolved the issue.

Best regards,

Hiro

Bluetooth®︎

Bluetooth forum

CC2651R3SIPA: Configure UART baudrate of host_test on CC2651R3SIPA