Health Thermometer

Roost Daniel

Other Parts Discussed in Thread: CC2540

Hello i have a question may it is not the smartes but i hope u can help me.

i put the sample app Health Thermometer on my peripheral device and my question is what do i need to put on my center device that the programm is running and i can see what the programm is doing.

thanks for the help

over 14 years ago

0 kazola over 14 years ago

Guru 18625 points

Hi Roost Daniel,

as this page says:

http://processors.wiki.ti.com/index.php/Category:HealthDemo

"The PC GUI runs on a Windows machine and controls a CC2540 USBDongle via serial commands. The USB Dongle should be loaded with master .hex file included with the binary zip. The CC2540 KeyFob should be loaded with the thermometer.hex file. "

;) Have a nice day

0 Roost Daniel over 14 years ago in reply to kazola

Prodigy 105 points

Hi thanks for the answer.

how do i load the hex file is that a different one then the one IAR?

0 kazola over 14 years ago in reply to Roost Daniel

Guru 18625 points

If you use IAR you can do it via the "download & debug" button.

If you use smartRF flash programmer, just browse to the hex.

0 Roost Daniel over 14 years ago in reply to kazola

Prodigy 105 points

Thanks i figured it out. the blood pressure is running good but with the thermometer it has difficulties connecting but thnks so much u helped me a lot

0 GammaPoint over 14 years ago in reply to Roost Daniel

Intellectual 270 points

Is there any documentation on how to connect the temperature & blood pressure sensors? And where to buy these sensors from?

0 Juli Wu over 13 years ago in reply to kazola

Prodigy 85 points

Hi Kazola

I noticed that in wiki page, but i'm wonder where is the master.hex ? Coudle it be replaced by HostTestReleaseCC2540Usb.hex?

Thank you for help!

Have a nice day!

Bluetooth®︎

Bluetooth forum

Health Thermometer