LP-CC2652RB: How to Connect external device (Mobile) with TI board

bhagyashree badiger

Part Number: LP-CC2652RB

Tool/software:

I want check how it works in advertising mode using "Btool". I am trying to configure TI board with Btool in this It could be able to scan the devices,

and it is displaying the number of scanned device but connect option is not enabled. how to connect the devices with the TI board.

8 months ago

0 Jan 8 months ago

TI__Mastermind 42100 points

Hi,

To send advertisements using host_test + BTool, you will need to cause a device reset through BTool (because BTool by defaults configure the connected device as central), configure the device as peripheral, create an advertising set, and then start advertising.

The E2E thread linked below shows a log of the commands necessary to start advertisign:

https://e2e.ti.com/support/wireless-connectivity/bluetooth-group/bluetooth/f/bluetooth-forum/1423703/cc2340r5-use-btool-to-send-advertisement

Best Regards,

Jan

0 bhagyashree badiger 7 months ago in reply to Jan

Prodigy 60 points

It is not able to scan our mobile phones but its showing 50+ devices scanned, but not getting which devices exactly?

0 Jan 7 months ago in reply to bhagyashree badiger

TI__Mastermind 42100 points

Hi,

Are you attempting to scan or advertise using host_test with btool?

Best Regards,

Jan

Bluetooth®︎

Bluetooth forum

LP-CC2652RB: How to Connect external device (Mobile) with TI board