CC2652R: regulated mode of CC2652

Albin Zhang

Part Number: CC2652R

Tool/software:

Hi There,

Noticed in the swra640, it mentioned the regulator mode only support on the CC26x0.

does it mean the CC2642 can't support this mode? neither the CC13xx?

if it is still supported on this generation, how to configure this in the SW?

thanks.

BR. Albin

0 xie yongqiang 5 months ago

1、是否适合1.8V电源域使用。

2、路把VDDS_DCDC直接接地了，是不是要把寄存器配置为0x1，有没有适配的固件。

3、芯片工作的正常配置流程。

0 Ryan Brown1 5 months ago

Hi Albin,

I apologize for the delay and have assigned a HW Apps expert to further investigate.

I had to remove your response since it was not written in English, please re-post after translating and your additional input will be reviewed.

Regards,
Ryan

0 Albin Zhang 5 months ago in reply to Ryan Brown1

Hi Ryan,

just support my questions firstly. I reviewed their sch, they used the 1.8V power configure and met some issues.

Let's confirm the regulated mode supporting and right SW configuration firstly, then we can move to next.

BR. Albin

0 FI 5 months ago in reply to Ryan Brown1

Hi,

Please refer to this thread regarding this.

thanks

Bluetooth forum