SimpleBLECentral Keyfob

amit singh6

Hello

I program this ( http://processors.wiki.ti.com/index.php/SimpleBLECentral_Keyfob )code on keyfob but it not flash green led on scanning .

I think this code is working for keyfob.

Regards

Amit Singh

over 10 years ago

0 J Lindh over 10 years ago

TI__Guru 57865 points

Hi Amit,

Are you running it on BLEv1.3.2 or have you ported it to BLEv1.4?

Best Regards

Joakim

0 amit singh6 over 10 years ago in reply to J Lindh

Intellectual 450 points

Hi Joakim

I run it on v1.3.2

Amit Singh

0 J Lindh over 10 years ago

TI__Guru 57865 points

Hey,

amit singh6 said:
I think this code is working for keyfob.

How do you know? Are you able to step through the code in debug mode?

0 amit singh6 over 10 years ago in reply to J Lindh

Intellectual 450 points

It uploaded on website with proper indication that

LED indicates different status:
Green LED is on, central is doing devices scanning.
Green LED is flashing, central has found a remote peripheral device.
Red LED is flashing, central is in connection procedure to a remote peripheral device.
Red LED is on, central has connected to a remote peripheral device.

If all these work means code works fine whatever given on this website (http://processors.wiki.ti.com/index.php/SimpleBLECentral_Keyfob)

Amit Singh

0 amit singh6 over 10 years ago in reply to amit singh6

Intellectual 450 points

Hello

Actually this code not working.

Regards

Amit Singh

Bluetooth®︎

Bluetooth forum

SimpleBLECentral Keyfob