MasterSlaveSwitch

Adris MOUANDA

Other Parts Discussed in Thread: CC2540, CC2541, CC2640

Hi,

I try to compile MasterSlaveSwitch project, and then i have this error:

Error[Pe020]: identifier "HCI_ProcessEvent" is undefined C:\Texas Instruments\BLE-CC254x-1.4.0\Projects\ble\MasterSlaveSwitch\Source\OSAL_MasterSlaveSwitch.c 92

I have looked in hci.h file and central.h file, i have seen nothing.

Can you help me. Thank you

over 11 years ago

0 YiKai Chen over 11 years ago

Guru 735695 points

If I remember correct, this example is base on BLE Stack 1.2 not 1.4. It seems that you use BLE Stack 1.4 to build the example and result in this issue.

0 Adris MOUANDA over 11 years ago

Prodigy 70 points

Thank you,

I have a CC2540, and i want to implement a firmware for use it in central role and peripheral role (switching role). Do you know a correct project i can use?

0 jerome d. over 11 years ago in reply to Adris MOUANDA

Expert 1365 points

Did you get an answer to this question ?
I'm also interested in implementing both central and peripheral roles in a single cc2541, based on 1.4 BLE stack.

Thanks

0 Tim C over 11 years ago in reply to jerome d.

TI__Mastermind 34660 points

Hello. The MasterSlave Switch project is based on the 1.4.0 stack, available on the wiki:

processors.wiki.ti.com/.../MasterSlaveSwitchV1_4

0 Tim C over 11 years ago in reply to Tim C

TI__Mastermind 34660 points

Note that this does not allow simultaneous master / slave functionality. You must switch between the two. The CC2640 with the 2.0.0 stack does allow simultaneous master / slave. See the example here:
processors.wiki.ti.com/.../Cc2640_MultiRole_Demo

Bluetooth®︎

Bluetooth forum

MasterSlaveSwitch