Programming CC2540 at In-circuit

Graham Whitehead

Other Parts Discussed in Thread: CC2540

Hi,

I have ben asked to investigate if it is possible to Program a CC2540 device at In-circuit test,

using an Agilent 3070 tester.

Has this been done before or have any case studies been done.

Thanks for any Help

0 Willis1 over 11 years ago

I am not familiar with anyone who has used the Agilent 3070 to program our CC devices.

0 Fredrik K over 11 years ago

Hi Graham,

I am not sure exactly what you need, but maybe this document can help: www.ti.com/lit/swra410/

Cheers,
Fredrik

0 Graham Whitehead over 11 years ago in reply to Fredrik K

Hi,

Thanks for the info.. I had one other question... Instead of using the GUI to run the software program/verify etc

I was wondering if there was a set of commands which could be run from a dos window. I had a look through

the datasheets but may be missing this...

Thanks again

Bluetooth forum