• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 51 subscribers
  • Views 594 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Can cc2564 evaluation board be interfaced with msp430 launchpad

Surya Banerjee
Prodigy 10 points

Other Parts Discussed in Thread: CC2564

I am sorry for posting such a basic question, but I am working on a TI University competition where I ordered a MSP430 launchpad and CC2564 evaluation board but it seems that both can not be interfaced to each other.(Atleast from what I have read). I would really like to get some opinions on how to go by in order to interface both of this part as I am really running out of time and out of money for getting the hardware development kits such as MSP-EXP430F5529,MSP-EXP430F5438, DK-TM4C123G, and DK-TM4C129X. I would really love to have some suggestions as I need it really bad to be interfaced.

  • 0
    TI__Mastermind 32615 points
    Hi,

    You can interface the CC2564 evaluation module (I hope you are using QFN module) as per the below CC256x main page refer to the Design Guides section processors.wiki.ti.com/.../CC256x, and you need to make the software modifications as per the hardware porting guide part of documentation folder in the SDK release.

    For initial bring up you need to make sure that you have interfaced UART (RTS, CTS, RX and TX) , nSHUTDOWN (nSHUTD) , clocks and power.