Hello. I am a college student who is seeking to develop beacon on my own.
So I recently purchased CC2650DK to develop proximity beacon.
I have read software development guide document, and I have decided to use proximity beacon project provided by simplelink ble stack as my starting point.
But I am little confused about the steps to develop beacon...
According to the wiki page, after downloading software tools, I need to design a hardware.
If I want to use similar PCB design as CC2650 board from development kit, how can I program my code into this chip?
Do I always need to plug new PCB board into XDS100 debugger and implement the program?
I would very appreciate your help!
