SmartRF06 CC2650 LED Sample code

We have a lot of example codes that contains LED toggling. But the most simple one will be the one comes together with our simplelink academy training.

software-dl.ti.com/.../tirtos_01_basic.html

Which can be downloaded here :
software-dl.ti.com/.../setup_simplelink_academy_01_03_00_0000.exe

Hello,

TI RTOS will include a "pinInterrupt" example showing how to read and set IO's which can drive LED's.
If using Code Composer Studio these can be found in the "Resource Explorer" tool inside CCS.

Regards,
Svend

I just not familiar with CCS tool , and thank you to remind me.

I am try to follow this document , Task 1 is success , but Task 2 is not any sample code ? where I can find it?

For task 2, you just need to copy and paste what we already have in the project and rename it.

If you read thru setting up the new task, you will find the instructions stating that copy and paste and rename the workTaskFunc function to create a new task function called urgentWorkTaskFunc...etc

Just follow the instruction and let me know if you still have problems

PIN_Config pinTable[] = {
Board_LED1 | PIN_GPIO_OUTPUT_EN | PIN_GPIO_LOW | PIN_PUSHPULL | PIN_DRVSTR_MAX,
Board_LED2 | PIN_GPIO_OUTPUT_EN | PIN_GPIO_LOW | PIN_PUSHPULL | PIN_DRVSTR_MAX,
Board_KEY_RIGHT | PIN_INPUT_EN | PIN_PULLUP,
Board_KEY_LEFT | PIN_INPUT_EN | PIN_PULLUP,
PIN_TERMINATE
};
//Task 2 do....
void doUrgentWork(void)
{
PIN_setOutputValue(pinHandle, Board_LED2, Board_LED_ON);
FakeBlockingSlowWork();
PIN_setOutputValue(pinHandle, Board_LED2, Board_LED_OFF);
}

Void workTaskFunc(UArg arg0, UArg arg1)
{
while (1) {

/* Do work */
doWork();

//Task 2 ?
doUrgentWork();

/* Wait a while, because doWork should be a periodic thing, not continuous.*/
CPUdelay(1e6);
}
}

where is "Board_KEY_RIGHT" function ?

I just want to that led on when I Key_RIGHT button press. Thank you.

You should try to make your own function. That's the point of the training. also the API to look for and which .c/.h files you should check are all stated in the html. Just read thru it and try to figure it out.

I have already find another sample code . You are right,TI's documents have a lot of sample code.Thank your help again.

Hi Tzuyu,

Nice to see your post.

Could you please let me know the another example related to Led On Off using a button press which you found please. Please tell me where you found it on TI web. Thanks

Regards,

You can either use a pin interrupt to accomplish this or simply a while loop and do the pulling for it. Both examples are included in the simplelink Academy training


Using interrupt
void pinInterruptHandler(PIN_Handle handle, PIN_Id pinId)
{
//toggle LED whenever right key is pressed.
PIN_setOutputValue(handle, Board_LED1, !PINCC26XX_getOutputValue(Board_LED1));

}


void main()
{
// ..................
// do whatever you want
PIN_registerIntCb(pinHandle, pinInterruptHandler);
PIN_setInterrupt(pinHandle, Board_KEY_RIGHT | PIN_IRQ_NEGEDGE);
}