Integrate Sensor Controller generated code in Example in Code Composer Studio

Miguel Castro Vieira

Hi,

I'm using Sensor Controller Studio to communicate with some sensors (as you already know). Finishing that part, i want to integrate the generated code to an example in CCS and read the values in the main CPU. Can you tell how do I do that? what I need no initialize and so on.

I already copy the generated files to my project, I started a new empty project where I just want to receive the values from the SC and present them.

Best Regards,

Miguel

over 8 years ago

0 Nathan Siegel over 8 years ago

TI__Genius 10980 points

Hi,

Please see the "Integrating Sensor Controller Driver with Application" section of the Sensor Controller Studio Frequently Asked Questions sticky on the first page of this forum.

-Nathan

0 Michel Solecki over 8 years ago

Mastermind 8415 points

Hi Miguel,

In addition to Nathan's suggestion, you can look at the examples provided with SCS (you can find them on the Start Page).

When you open the example projects, the scif files are generated but you will also have a main that shows how the code was integrated. On your computer, they should be located in "My Documents\Texas Instruments\Sensor Controller Studio\examples".

Try to take an example that comes as close as possible to you have done in your project.

I hope looking at the examples will help you figure out how to integrate your code into your project.

Regards,
Michel

0 Christin Lee over 8 years ago

TI__Guru 56525 points

You can also take a look at simplelink_academy training, there is a session for integrating scs code into BLE
software-dl.ti.com/.../sc_01_project_from_scratch.html

Bluetooth®︎

Bluetooth forum

Integrate Sensor Controller generated code in Example in Code Composer Studio