LAUNCHXL-CC2650: Specify PRBS9 and -10dBm during Packet TX using SmartRF Studio 7

Jehangir Parvereshi

Intellectual 510 points

Part Number: LAUNCHXL-CC2650

Hi,

How do I use SmartRF Studio 7 (2.5.1) to generate a -10dBm, PRBS9 TX packet from a LaunchXL-2650 eval board.

i did not see a user's guide for SmartRF Studio 7 on your site.

Thanks.

over 9 years ago

0 Marie H over 9 years ago

TI__Guru* 83901 points

Hi JP,

There is a help document that you can access on the top right corner of SmartRF Studio 7. Or you can look at the files locally (e.g. C:\Program Files (x86)\Texas Instruments\SmartRF Tools\SmartRF Studio 7).

0 Jehangir Parvereshi over 9 years ago in reply to Marie H

Intellectual 510 points

Hi Marie:
There's no reference to PRBS9 in the help document you referred me to.
Do you know if the tool can be used to generate PRBS9 sequence?
-JP

0 Eirik V over 9 years ago in reply to Jehangir Parvereshi

TI__Guru 56590 points

Hello Jehangir,
As far as i know you cannot generate these test pattern from SmartRF Studio. Try to load the HostTest project for Launch Pad and use BTool instead:
processors.wiki.ti.com/.../PTM

Bluetooth®︎

Bluetooth forum

LAUNCHXL-CC2650: Specify PRBS9 and -10dBm during Packet TX using SmartRF Studio 7