How to change the .brd file configuration in Sensor Controller Studio for own hardware

kaleeshwari Ponkalimuthu

Other Parts Discussed in Thread: CC2640R2F

Hi Everyone,

I would like to integrate my own hardware with Sensor controller Studio.

Please help me to create custom board files (.brd file )

Custom board details:

The chip name is: CC2640R2F from TI
The package is a die from 5x5mm RHB chip package.
Number of GPIOs: 15
The pinout of the module is exactly same like saBLE-X-R2 Module

Thanks in advance.

over 7 years ago

0 Fredrik K over 7 years ago

TI__Guru** 106705 points

Hi,

I am not sure what you are asking for here. .brd file is the board file from the PCB design tool, Cadence Allegro. It is not related to the Sensor Controller.

Cheers,
Fredrik

0 kaleeshwari Ponkalimuthu over 7 years ago in reply to Fredrik K

Intellectual 400 points

Hi Fredrik,

What about the highlighted box on the below attached I/O mapping Image from Sensor Controller Studio??

0 Fredrik K over 7 years ago in reply to kaleeshwari Ponkalimuthu

TI__Guru** 106705 points

Hi Ideazee,

You are right. In your case I would simply start off of the 5x5 QFN reference design and configure from that.

Cheers,
Fredrik

Bluetooth®︎

Bluetooth forum

How to change the .brd file configuration in Sensor Controller Studio for own hardware