CC2640R2F: Custom Broad Design

Vijay Rakesh Munganda

Part Number: CC2640R2F

Hi,

I would like to design a custom board for CC2640R2F and I found some design files in TI website (file attached below). Is this schematic design file is enough for programming the IC and works every functionality as CC2640R2F launchpad kit. If not please suggest me and I'm not able to find some components mentioned in BOM is there any preferred site where I can get all components at once.

Regards,

Vijay Rakesh

LAUNCHXL-CC2640R2_1_0_0_Schematics.pdf

over 7 years ago

0 TER over 7 years ago

TI__Guru**** 317180 points

Do you basically want to make a Launchpad? If so, why?

0 Vijay Rakesh Munganda over 7 years ago in reply to TER

Expert 1150 points

Hi Ter,

I don't want to make a launchpad, I want a create custom broad for our product which can support on broad programming.

Regards,
Vijay Rakesh

0 TER over 7 years ago in reply to Vijay Rakesh Munganda

TI__Guru**** 317180 points

Then start for one of the EM designs listed under Desgn FIles (www.ti.com/.../technicaldocuments), remove the EM connectors and add a jtag interface. You can also look at the CC2640R2 part of the LP, you don't need to include the debugger.

0 Vijay Rakesh Munganda over 7 years ago in reply to TER

Expert 1150 points

Thanks for the reply, In above link there are 9 Design files, SimpleLink CC2640R2F WCSP EVM v1.1.0 Design Files is the suitable file for me?

0 TER over 7 years ago in reply to Vijay Rakesh Munganda

TI__Guru**** 317180 points

That depends on which frontend configuration and packet size you want to use on your board.

0 Vijay Rakesh Munganda over 7 years ago in reply to TER

Expert 1150 points

Is there perfered online store to by the BOM? I can't find some components in online stores.

0 TER over 7 years ago in reply to Vijay Rakesh Munganda

TI__Guru**** 317180 points

Normally either Digikey or Mouser should have most of the parts.

Bluetooth®︎

Bluetooth forum

CC2640R2F: Custom Broad Design