CCS/CC2650: cc2650;I2C TMP007 example doesn't want to load

Jeroen Wyffels

Part Number: CC2650
Other Parts Discussed in Thread: TMP007

Tool/software: Code Composer Studio

Hi,

When using the resource explorer in CCS, I want to open the I2C TMP007 example. CCS complains about no build-tools being installed for ISA family 'ARM4, although I can verif this is the case.

Any remedy for this issue would be appreciated!

regards

Jeroen

over 5 years ago

0 AB over 5 years ago

TI__Mastermind 20625 points

Hello,

What version of CS is this?

0 YiKai Chen over 5 years ago

Guru 735515 points

In CCS, there are two resource explorers, Resource Explorer and Resource Explorer Classic, and you shall use Resource Explorer instead of Resource Explorer Classic.

0 Jeroen Wyffels over 5 years ago in reply to AB

Prodigy 220 points

CCS 6.1.

Mainwhile, I've been able to load the project, and build it. However, the debug function is not available since the error presented below is thrown...

What can be causing this?

Cortex_M3_0: Failed Board Reset
IcePick_C: Error connecting to the target: (Error -600 @ 0x0) A required dynamic library could not be located. The library isn't on the search path. (Emulation package 5.1.641.0)

0 YiKai Chen over 5 years ago in reply to Jeroen Wyffels

Guru 735515 points

Your CCS version is too old. Try to update it to CCS 8.3 to test again.

Bluetooth®︎

Bluetooth forum

CCS/CC2650: cc2650;I2C TMP007 example doesn't want to load