CCS/CC2650: Set up Sleep mode in HID sample project CC2650

Luong The Phong

Part Number: CC2650

Tool/software: Code Composer Studio

I am using HID sample project. I want to set up sleep mode. Can you show me how to set sleep mode?

0 YiKai Chen over 7 years ago

Guru 735695 points

I remember it should enter sleeping mode automatically. Do you see problem in power consumption?

0 Luong The Phong over 7 years ago in reply to YiKai Chen

I measure the current consumption = 9mA. Target current consumption I want = 0.0x mA

0 YiKai Chen over 7 years ago in reply to Luong The Phong

Guru 735695 points

Do you check if there’s IO leaking current.

0 Luong The Phong over 7 years ago in reply to YiKai Chen

So how to stop this problem.

0 YiKai Chen over 7 years ago in reply to Luong The Phong

Guru 735695 points

Do you use LAUNCHXL-CC2650?

0 Luong The Phong over 7 years ago in reply to YiKai Chen

I use Kit CC2650 laundpad

0 YiKai Chen over 7 years ago in reply to Luong The Phong

Guru 735695 points

When you measure power consumption, do you remove all jumpers and give power from 3V3/GND puns?

0 Luong The Phong over 7 years ago in reply to YiKai Chen

after I removed jump, current = 0.11mA.
Does it get down to 60uA?

0 YiKai Chen over 7 years ago in reply to Luong The Phong

Guru 735695 points

Try to turn off external flash.

0 Luong The Phong over 7 years ago in reply to YiKai Chen

In the shutdown state, my device will save energy, whether two devices are still connected in this state?

0 YiKai Chen over 7 years ago in reply to Luong The Phong

Guru 735695 points

In shutdown mode, it will disconnect.

0 Luong The Phong over 7 years ago in reply to YiKai Chen

Thanks for your support.

Bluetooth forum